LaserSoft Imaging

I have loved using SilverFast for the past four years. I am preparing to upgrade to the Mac OS "Leopard." Is there a Silverfast driver that is compatible with my beloved ScanMaker 6800 and Leopard?

Thank you for four years of ease of use and quality results.

Barbara

Dear paws,

We have not positivly testet th ScanMaker 6800 yet with leopard.
I would suggest you try our free demo version if this works at your site the full version will do so aswell.

for an up to date list about scanners that we Support on Leopard have a look at the following Website.

http://www.silverfast.com/show/leopard/en.html

kindest regards,

Thomas Lübker
LaserSoft Imaging AG

Thank you, Thomas!

Hi,

Are you intending to support the 6800??

I now have a scanner I cannot use! 6.4.4.r6 will not recognise the scanner under 10.5.x

Thanks

Dear Customer,

please try the 6.6 Demo Version as we have not tested the ScanMaker 6800 positivly back.
We are looking forward for your feedback.

best regards,

Thomas Luebker,
LaserSoft Imaging AG

The Silverfast Launcher will launch but the Scanner is not recognised.

The PhotoShop PlugIn does not recognise the scanner either.

Dear Customer,

have you tried installing the latest ScanWizzard Software from Microtek before installing SilverFast ?
We would need some of the resources installed by ScanWizzard in oder to communicate with the Scanner.

best regards,

Thomas Luebker,
LaserSoft Imaging AG

Does not work I'm afraid. Tells me that An error occurred attempting to calibrate the scanner.

v**s**n works fine with this scanner, so what is wrong with SilverFast?

Dear Customer,

I just tried our Scanmaker 6800 and it worked well on my MacPro running OSX 10.5.5 with the latest SilverFast version.


best regards,

Thomas Lübker
LaserSoft Imaging AG

Hi Thomas,

Was that under USB or FW400? ANd was the 6800 via a hub or direct in the case of USB?

Thanks

Dear Customer,

I used the scanner via FireWire connected to the FireWire Hub in my Apple Display.

best regards,

Thomas Lübker
LaserSoft Imaging AG

Thomas, Could I ask also what version of Microtek's ScanWizard software you are running?

Thanks

Der Customer,

I used the latest version of scanmaker 5 which can be downloaded from the Microtek Website:
http://202.39.72.2/installer/mac/sw5/sw5_7220_eu.dmg

best regards,

Thomas Luebker,
Laserssoft Imaging AG