LaserSoft Imaging

I recently purchased the Plustek 7200 with Silverfast SE.

When I preview a slide with a slide viewer, it looks fine. However, when I scan the slides, they come out with a grey/cloudy hue throughout the output. I thought it was caused by the brightness setting being too strong, so I reduced that, but still I get the grey cast. It is especially prevalent on darker slides. They are still bright enough for the viewer, but the scann gives them a cloudy hue.

Is there a setting I need to adjust to get rid of the cloudy hue, besides the brightness adjustment, which I have tried?

Thanks for any help offered.

Dear mshepley,

did you try to set the black point with the black pipette?
or try to use the image automatic tool?

Best regards
Martin