LaserSoft Imaging

My intelliscan button does not work.
The quickscan button does work.
Probably did something wrong during installation.
How do I activate this button.
Many thanks,
Roger

Roger,

Are you talking about buttons on your scanner? I have not seen anything like them in SilverFast, but I am using a different scanner.

Yes,
I am talking about two buttons on the scanner.
Roger

Are you saying the quick scan button works with SilverFast, or does it start the software that came with your scanner?

There are two buttons on my scanner.
One button called Quickscan starts software that came with my scanner: NewSoft Presto! Pagemanager.
The other button called Intelliscan should start the SiverFast SE 6 programm that was also delivered with my scanner.
I installed first the NewSoft software and the driver.
Afterwards I installed the SilverFast programm.
But the scanner already sayed by pressing the Intelliscan button that SilverFast was not installed.
Untill now ( after installing SilverFast ) and pressing this button I receive the message : The SilverFast programm is not found, please install.
Is there a mean to install that button afterwards?
Roger

I think you may need to contact Plustek technical support on this one.

Anonymous wrote:I think you may need to contact Plustek technical support on this one.

Normally when I click the reply button I am prompted to Log on to the forum, but this time it posted my reply as "guest"