LaserSoft Imaging

PostPosted: **Wed Aug 05, 2015 9:03 am**

Hello LaserSoft

I'm trying to calibrate OF 120 using a 6x7 IT8 calibration target. Film holder supplied with the scanner does not allow me to "Adjust the scan frame shown in the picture". I can fix the target in the holder where it is tilted by 90%. See attached picture.

Look forward to your suggestion to resolve this issue
Thanks

PostPosted: **Thu Aug 06, 2015 4:28 pm**

Dear customer,

can you please switch to positive mode.
It seems you are in Negative mode.
You can also turn the scan frame by dragging each of its corners to the correct position.

Kind regards,
Arne Ketelhohn.

LaserSoft Imaging

PlusTek OF 120 Calibration : Orientation of 6x7 IT8 target?

PlusTek OF 120 Calibration : Orientation of 6x7 IT8 target?

Re: PlusTek OF 120 Calibration : Orientation of 6x7 IT8 targ