Page 1 of 1
NO SCANNER FOUND - check delay not long enough
PostPosted: Thu Jan 22, 2004 8:01 pm
by BEIGE
well i managed to get my touchy Umax Powerlook 2100XL/Belkin SCSI to firewire adapter/SF6/Panther/dual G5 setup working fine (SCSI ID 2 IS YOUR FRIEND) but one thing that is still a problem is that i can't use batch mode. when SF6 checks for the scanner to do the second scan, it says that the scanner can't be found. "it's sitting right there," i yell but nothing works. the software loads again fine shortly after the optics return to the start zone. i suppose this will have to be solved with code and not words. please fix this. thanks.
PostPosted: Fri Jan 23, 2004 4:36 pm
by LSI_Rossee
Dear Beige.
Are you describing the regular Batchmode or scanning out of the Jobmanager. Does this happen after ...
- setting the frames
- opening the Jobmanager
- adding the selections to the Jobmanager
- editing the frames
- starting the Job ??
Please also provide the SF_logfile to
support@silverfast.com.
Thanks in advance.
PostPosted: Fri Jan 23, 2004 5:50 pm
by BEIGE
it happens in batch mode. i will try the job manager.
PostPosted: Fri Jan 23, 2004 6:05 pm
by BEIGE
it works with the job manager. still i prefer to use the batch mode because i do tweaks in photoshop first and rarely want my scans in the same directory. but i'll use it in the meantime. thanks.