How to update firmware on Howtek D4000
PostPosted: Thu May 14, 2015 9:38 pm
Hi,
I am attempting to resurrect a Howtek D4000 that has been sitting in storage for a very long time. It turns on fine all the diagnostics are fine. I got silverfast to recognize it and open, but when I try to do a prescan I get "cannot set window" or "cannot auto focus" if the auto focus is on (but it focuses fine manually). I saw on a different forum (howtek-d...end-t4156.html) that someone else had the same problem, that was fixed after updating the firmware. I found and downloaded the r535 firmware from Aztek, but I cannot figure out how to install it. I opened the program, a box came up then closed, leaving a .hex file and another program that does not seem to do anything. I am using a windows 7 machine with an Adaptec 2930CU card. I really just need to know how to update the firmware on the D4000.
Any help or ideas would be great.
I am attempting to resurrect a Howtek D4000 that has been sitting in storage for a very long time. It turns on fine all the diagnostics are fine. I got silverfast to recognize it and open, but when I try to do a prescan I get "cannot set window" or "cannot auto focus" if the auto focus is on (but it focuses fine manually). I saw on a different forum (howtek-d...end-t4156.html) that someone else had the same problem, that was fixed after updating the firmware. I found and downloaded the r535 firmware from Aztek, but I cannot figure out how to install it. I opened the program, a box came up then closed, leaving a .hex file and another program that does not seem to do anything. I am using a windows 7 machine with an Adaptec 2930CU card. I really just need to know how to update the firmware on the D4000.
Any help or ideas would be great.