LaserSoft Imaging

I suppose Minolta Scanners are very widespread because of their affordable price. That?s exactly why I cannot understand that the number one company in scanning software doesn?t support Minolta products.

I guess I am not the only one looking forward to Minolta support.

Stefan :(

Dear Stefan.

We are currently working on the Minolta scanners. Support is coming soon.

Eric.

SilverFast Ai for Minolta is here!


https://www.silverfast.com/show/scanners-minolta/en

Support for my Minolta Scan Dual III is not "here." When going to the above link, my scanner is not listed as supported or possibly supported. When will this very good and affordable scanner be supported?

Thank-you.

My primary scanner is the Minolta Scan Dual III.

Why is this not supported?

Will it be added soon as a supported product?

The Dual Scan III is now in the list of supported products, but it is not clear what product actually supports it because when you try the demo there is no demo that supports it, what do i have to do to try Ai with the DSIII???

http://www.silverfast.com/product/Minolta/en.html

According to jcr, the Dimage Scan Dual III was listed as a supported product. Unfortunately, it is no longer so. Silverfast SE came with my Epson 3200, but before I upgrade to AI, I want to make sure the software is compatible with my Minolta scanner. Can we expect support for the Scan Dual III in the near future? If so, when? Thanks in advance for any reply.

hi,

i have short question, is there any possibility of silverfast support for the dual scan III? i am one of the moderators of the minolta-forum and i get a lot of questions about the minolta scanners and silverfast.
i own a nikon ls4000 and a dual scan III and i want to use silverfast for both scanners.
thanks for your answers,

with best regards,
Mark

Dear noah11027.

Thank you for the interest in our SilverFast Software.

We are planning on supporting the Scan Dual III with Silverfast but development will take a couple more weeks. I will inform the development and product manager about the increasing number of requests here in the forum.
I will post the good news here once it is available.

Kind regards.

LSI_Rossee,

Thanks for working on support for the Scan Dual III. Like others on this forum, I too have been waiting for Scan Dual III support before I purchase SilverFast. Please add my request to the list!

Thanks,

Normdeplume

The III appeared in that page one day and then it wasn't there anymore, which is ok because it is NOT supported. LSI_Rossee said in Dec 2003 that they were working on it and that it would take another 2 weeks... 2 months after it is still not there...

I am fed up waiting for LSI support for the Dual 3. I shall remove them from my 'Favourites' and forget all about it.

Ron

any updates on this topic?


scan dual III owner

Dear All.

We now support the Minolta DiMAGE Scan Dual III and DiMAGE Scan Dual IV filmscanners.

Both are priced EUR 228,- incl. optional IT8 calibration and the necessary 35mm target.

SilverFast Ai and demo versions are available --> https://www.silverfast.com/product/Minolta/433/en.html

Have a nice day !

Hallo,

i'm sorry, but i'm a little bit dissapointed about the very expensive pricing, 228$ is the nearly same amount as the price for the scanner itself.
Are there any price specials in planing with minolta? I'm waiting a long time for the DSIII Support, but i guess i dont wanna buy it. I guess it's better to buy a new Scanner with a Siverfast Bundle.

Mark