LaserSoft Imaging

I use Canoscan 2700F (with canoscan 3.6 software) ; I have tried silverfast
SE (free demo) and this software is better than canoscan 3.6 on every items (speed ++ !! especialy) .
But for me there is only one point which has been forgotten by the developper :

the calibration of CCD (special sequence at the ligth on of canoscan and evey 50 minutes ) with canoscan 3.6 you can do it anytime as you want. Silverfast don't process the message from the scan when it is time to do calibration and there a error message. It is "diagnostic " command in canoscan 3.6.


Can you do something to make silverfast absolutely perfect ?


thank you and apologize for my bad english

Adolphe from Fort de France

Dear Adolphe,

thank you very much for the message.
I will analyse the problem as soon as possible and
post a message when I have fixed the problem.

Regards

Martina Steidele
LaserSoft Imaging