Page 1 of 1
Feathering Lasso selection edges
PostPosted: Mon Apr 14, 2003 6:58 am
by MartyS
Unless I tried it incorrectly???....It would be nice to be able to feather the hard edges of the lasso selections you apply changes to in the prescan image.
When correcting selected areas it is important to have a soft blending into the surrounding image.
Just a thought.
Thanks
Marty
PostPosted: Tue Apr 15, 2003 6:48 am
by LSI_Flyvbjerg
Dear Marty.
Please open the option dialog and go to the general panel. Set the "mask edge size" to any other value than 0.00. The unit is inch, the valid range is 0.00 .. 1.00. A soft mask is then used inside the given mask with the given distance.
Eric.
I Do not have 'mask edge size" option?
PostPosted: Tue Apr 15, 2003 2:19 pm
by MartyS
Hello Eric,
I dont see a "mask edge size" you mention when I go to Option/General .
Could it be that I am using release Ai 5.5.2r20 ?
Thank you for yor response and assistance on this.
Marty
PostPosted: Tue Apr 15, 2003 4:18 pm
by LSI_Flyvbjerg
Dear Marty.
Right, that?s the problem, soft masks came with version 6
.
Eric.