Automatic pre-scan of film straps
PostPosted: Tue May 09, 2017 7:47 pm
Hi all.
I would like to suggest a function that enables an automated pre-scans for film and negative scanners like the Reflecta RPS 10M.
After adding a complete strap of film to the job manager, one has to pre-scan every picture separately, before one can apply the special settings to the single frame inside the job manager. Unfortunately, this take a lot of time. To prepare a normal 135/36 film means about 1h to 1,5h of work while the required adjustments would only take 30sec. per picture. Most of the time is wasted by useless waiting for the next picture to be pre-scanned.
Therefore, I would like to see a function inside the job manager, that automatically pre-scanns a whole strap of film, so the adjustments might be done at a stretch afterwards and can be done in 15 to 20 minutes.
Thank you in advance
Holger
I would like to suggest a function that enables an automated pre-scans for film and negative scanners like the Reflecta RPS 10M.
After adding a complete strap of film to the job manager, one has to pre-scan every picture separately, before one can apply the special settings to the single frame inside the job manager. Unfortunately, this take a lot of time. To prepare a normal 135/36 film means about 1h to 1,5h of work while the required adjustments would only take 30sec. per picture. Most of the time is wasted by useless waiting for the next picture to be pre-scanned.
Therefore, I would like to see a function inside the job manager, that automatically pre-scanns a whole strap of film, so the adjustments might be done at a stretch afterwards and can be done in 15 to 20 minutes.
Thank you in advance
Holger