Page 1 of 1
PostPosted: Fri Aug 31, 2001 3:40 pm
by Stefan
My Powerlook has a high res area,that uses different lenses than the "normal" area.Those lenses produce different colors, so it would be necessary to calibrate seperately for both areas.So I could get 2 transparecy and two reflective calibrations.
Stefan
PostPosted: Fri Aug 31, 2001 10:47 pm
by President_LSI
Calibration Differences with Umax PL3000 and high resolution optics
We will check on this issue of differences between different optics and see what we can change!
PostPosted: Fri Aug 31, 2001 11:11 pm
by adagency
Scanning with a Umax PowerLook 3000 and SilverFast AI 5.5 in the DOR mode (transparency or reflective) deactivates the calibration.
There is also no 35mm slide to calibrate this area included in the SilverFast it8 package.
PostPosted: Fri Aug 31, 2001 11:12 pm
by adagency
<font size=-1>[ This Message was edited by: adagency on 2001-09-01 00:13 ]</font>