LaserSoft Imaging

Hallo,
ich f?nde es gut, wenn im SRD Modul eine Zoom-Funktion eingebaut ist. Bei einem Scan mit 4000 dpi und Ausgabegr??e 20x30 erhalte ich ein gro?es Bild mit vielen Kacheln im Navigator. Oft komme ich dann mit den vier Layern f?r den Ausschlu? von Bereichen nicht aus. Evtl. w?rde eine Scrollfunktion auch reichen, die Maske ?ber den Auschnitt hinaus zu ziehen.
Gru?
Uwe

Dear Uwe,

I just briefly translate for people who can understand german (please write in english the next time if possible, thanks ). So you wrote approximatively that:

You'd like to have a zoom integrated to the SRD tool because at high resolutions you get many tiles in the navigator window. Moreover, four layers are too short for excluding regions. You propose to use scroll bars to extend a mask from a tile to another one.

So first, thanks for the comments. And secondly, we have in mind some improvements, but they are not fixed yet.

In the meantime, you have these options:
- You can draw a mask directly in the navigator, so you are not restricted to a tile
- You can extend a mask by using the mouse and the SHIFT-key (exclude a region with the ALT-key)

That means that, for a set of parameters, one layer should be enough for excluding regions.

I hope this helps. Again, thank you for your proposals.

Regards.

Thomas

Hallo Thomas,
thank's for your tips. I didn't knew before, that I can draw a mask directly in the navigator. I'm sure, it will help to fix my problem.
Uwe