LaserSoft Imaging

I bought circon scanner, I use with pc. Silverfast 6 demo not use high resolution lenses. What can I do? In the near future will it be new type of software?[/b]

3rd lens Circon Scanner with SilverFast

We are waiting for information from the manufacturer of that scanner, so we can address the 3rd lens.

Thank you for your information. can you tell me what time arrive the new softwre version, with working the high resolution 100% perfectly.

It's actually the mid lens the 1200 dpi lens that isn't yet supported. Other than that I've been getting very good scans , especially from negs with Silverfast. The only draw back is scanning prints with the 800 dpi lens as on the Circon it's not very sharp.
Hopefully this mid lens support will be made available soon. It's the only thing holding me boot in OS 9 and using Linocolor.
Also be aware that the Circon has only 2MB of buffer , so 16 bit scans require many stops while scanning. It's worth the extra bit information if you're not sure of future corrections and /or if you use the HDR options of raw scans.

3rd lens for the Circon scanner now supported

The third lens in the Circon scanner is now supported. It enables to make scans with an intermediate optical resolution. The supported optical resolutions available now are: Standard-Res Mode: 800 x 2400 dpi; High-Res Mode: 1200 x 2400 dpi; Super High-Res Mode: 2400 x 2400 dpi.

Thomas

Hi,
I would like download update versions Windows: 6.0.2r33, but did not find only linoscan 1r44 version. How can I download this version.
Please help me

Please be patient A new version 602r33 for Windows should be available tomorrow. The version 602r34 for Mac will be available at the end of next week.

Thomas

Hi,
I download update and, install. But the middle and high resolution lens still untill not working. Starting the scan (1200 dpi centre the scanner plate), see on the scanner display "low resolution". When scanner power on, to write on the display "CIRCON V01.01". In the silverfast logfile "vendor : LinoHell
: product : ELS5000
: firmware: 0108". What is the problem? How update scanner firmware?
Thank you all response.

I interested in that on the problem is succesful accomplishment.
Thank You !!!
Attila

Yes , bravo to the Lasersoft developers, a work well done deserves much credit.
It works beautifully on the Circon prolonging the life of this old scanner with first grade up to date software.

Hi Group,

When will the 6.0.2r34 English version for Mac OS X that supports the 1200 dpi optical scaning resolution be posted?

Thanks,

Ray

Hi Ray,
Nice to see you here on this forum too.
The 6.0.2.33 was put up on the site for the registered users about two weeks ago. Works great. Too bad Lasersoft didn't make a version for my ICG drum scanner