LaserSoft Imaging

Hi

Got IT8 calibration target
put it into my flatbed canon 9000F mark II
and scanned it with silverfast 8.80r3
that is
i pressed the IT8 CAL buttom
a small window with the target appear
telling me "scanning" -> "zoom" -> "Create ICC profile" (and that window is "on top" of every other windows)
a smaller windows "SilverFars8 - Success" appear (underneath the abow mentioned)
telling "IT8 Calibration succeeded with DeltaE = 1.8"
I can only press OK
and then fini
----
1) according to your movie I can name the profile ! I did NOT get the opportunity !
2) where in SF do I find the profile ?

Dear customer,

individually naming the file is normally not necessary. You can however activate that option in the preferences' Auto tab.

Kind regards,
Arne Ketelhohn.