Canascan 9000F distorted output
PostPosted: Mon Feb 23, 2015 8:11 am
Hey Forum
I have earlier written concerning a problem I have with Canoscan 9000F and Canoscan 9000F Mark II. I have further information. I will post it all.
I had worked with Canoscan 9000F on both my 32 bit and 64 bit Windows 7 computers. I have never had any problem, I was actually very impressed with the software (Silverfast SE 8.2).
I also have a Plustek Optekfilm 8200i using Silverfast 8 SE Plus.
Then about a month ago I wanted to use the Canoscan 9000F again. I wanted to scan BW negatives
The preview picture was OK, but the scanned final output was very distorted.
I thought the scanner was broken and bought a new scanner Canoscan 9000F Mark II.
That did not solve the problem. I tried both the old and the new scanner on 32 bit Windows 7, 64 bit Windows 7, 64 bit virtual Windows 7, 64 bit Windows 8,1. Same problem.
I then the used the software that came with the Canoscan 9000F Mark II and had no problem with the output. The output was not distorted. I prefer to use Silverfast though.
I then tried to scan photoes and found out that the output was OK with both scanners.
I hope you can help solve this problem. I need to know very soon as I still have some days left to return the scanner I might have bought without actually needing a new scanner as the problem was not the scanner but the software.
I have earlier written concerning a problem I have with Canoscan 9000F and Canoscan 9000F Mark II. I have further information. I will post it all.
I had worked with Canoscan 9000F on both my 32 bit and 64 bit Windows 7 computers. I have never had any problem, I was actually very impressed with the software (Silverfast SE 8.2).
I also have a Plustek Optekfilm 8200i using Silverfast 8 SE Plus.
Then about a month ago I wanted to use the Canoscan 9000F again. I wanted to scan BW negatives
The preview picture was OK, but the scanned final output was very distorted.
I thought the scanner was broken and bought a new scanner Canoscan 9000F Mark II.
That did not solve the problem. I tried both the old and the new scanner on 32 bit Windows 7, 64 bit Windows 7, 64 bit virtual Windows 7, 64 bit Windows 8,1. Same problem.
I then the used the software that came with the Canoscan 9000F Mark II and had no problem with the output. The output was not distorted. I prefer to use Silverfast though.
I then tried to scan photoes and found out that the output was OK with both scanners.
I hope you can help solve this problem. I need to know very soon as I still have some days left to return the scanner I might have bought without actually needing a new scanner as the problem was not the scanner but the software.