Hi !
Yes, i "use" this combination.
i only can scan a framed silde.
its NOT possible to scan a filmstrip.
the scanner pull the filmstrip to the end and shows 101 empty thumbs,
than the strip is pulled back to the start, but the scanner does NOT STOP. the scanner does not show thumbs. only switch off stops the scanner. in my opinion the scanner /software does not to recognize the filmend. with the microtek cyberview35 scansoftware it works fine.
i hope lasersoft will find a solution
with the slide silverfast is working great. a very good, powerfull software!!
best regards
peter
