Silverfast Ai Image Type Option Will Not Change
PostPosted: Thu Sep 25, 2008 9:12 am
Hi,
I have the following problem.
I am using Silverfast Ai V6.4.5r4b with a Microtek 4000tf film/slide scanner.
I was scanning a few slides and decided to see what one of them looked like when the Image Type option in the Frame tab was changed.
I returned the Image Type selection to the Standard option but any new prescans/scans remain in another option (I think it is Technic).
I have tried changing the Image Type again, resetting all the options and reinstalling the Silverfast MicroIT8 software.
The reinstalled software picked up old configuration options so the uninstall operation does not do a complete uninstall.
The software is currently unusable. Any ideas to correct this problem would be appreciated.
I have the following problem.
I am using Silverfast Ai V6.4.5r4b with a Microtek 4000tf film/slide scanner.
I was scanning a few slides and decided to see what one of them looked like when the Image Type option in the Frame tab was changed.
I returned the Image Type selection to the Standard option but any new prescans/scans remain in another option (I think it is Technic).
I have tried changing the Image Type again, resetting all the options and reinstalling the Silverfast MicroIT8 software.
The reinstalled software picked up old configuration options so the uninstall operation does not do a complete uninstall.
The software is currently unusable. Any ideas to correct this problem would be appreciated.