LaserSoft Imaging

Hello,
I'm not quite clear whether the frame alignment button works with the artixscan 120tf but, after trying to set it, it's now stuck so that it only scans the last frame and then scans the black plastic twice after that - it's set on 6x7 so there should be 3 frames. I've tried resetting it but is there any way of deleting the last overview scan - it just seems to come back if I remove silverfast and reinstall it. Any ideas?
Dan

Have you tried pressing the delete key when you see this overview scan?

I have a similar problem - trying to scan 6 x 6 transparencies, the latest version of SF (6.4.5r4b) will only scan a small part of a film strip. If I go for an overview of all the images on a strip, it goes over just a small part of the strip 4 times.