Saving settings
PostPosted: Fri Jul 20, 2012 1:53 am
I am using Silverfast SE version 8 and I find that every time I open the program it has forgotten my previous settings. Is there somewhere where I can save settings, e.g. a profile for a particular type of job? For example, every time I start the program, it starts up with gradation, dust & scratch removal, grain & noise elimination checked by default. Every time I have to go and uncheck these options. 
There are other settings also which I have to set every single time. It would save a lot of time if Silverfast would at least remember the settings from my previous session. Ideas??? thanks!! 
There are other settings also which I have to set every single time. It would save a lot of time if Silverfast would at least remember the settings from my previous session. Ideas??? thanks!!