Page 1 of 1
Auto calibration does not detect the target
PostPosted: Sat Feb 27, 2010 3:41 pm
by RobertK
Hi,
I'm not able to use the auto calibration. SF does not enable the Start button, also not when I set exact the corners of the mask.
Do you have an idea?
THX
Robert
Re: Auto calibration does not detect the target
PostPosted: Wed Mar 03, 2010 3:07 pm
by LSI_Ketelhohn
Dear Robert,
The automatic calibration should set the grid and finish the process without any interaction.
Does the process stop at this point?
Normally it should do some scans and finish the process by itself.
If you have any problems during the process you can deactivate the automatic calibration in the option's "Auto" tab.
Kind regards,
Arne Ketelhohn.
Re: Auto calibration does not detect the target
PostPosted: Wed Mar 03, 2010 6:50 pm
by RobertK
I could solve the problem in the meantime by deletion of SF_T (Nikon LS-5000).icm at C:\Windows\System32\spool\drivers\color\. I can't explain why this works, but now I'm able to create further icm-files via calibration independent if this file exists or not.
Thanks
Robert
Re: Auto calibration does not detect the target
PostPosted: Thu Mar 04, 2010 5:40 pm
by LSI_Ketelhohn
Dear Robert,
make sure your profile folder does not contain too many profiles.
Windows can only manage around 170 of them.
kind regards
Arne Ketelhohn