Howtek 4500 + Silverfast AI
PostPosted: Tue Aug 11, 2009 9:42 pm
Just throwing this out here to see if someone knows a solution.
I go to do a prescan in silverfast.
scanner starts up
after 3-4 seconds, scan stops and I get a calibration error (f702)
I've checked the lamps, checked the drive belt.
The machine has worked for the last 18 months, but I have not used it in 3 months.
I'm wondering if the issue is hardware, software, or scsi connection somehow timing out. I've switched scsi cards, ports, reboot, etc.
If anyone has experienced this, I'd like to know a better work around than the $2500 + shipping that Aztek suggests.
This happened to me once before, but the lamp just needed alignment...not the case this time.
Does silverfast have a log file of errors to help make sense of the problem?
Many thanks!
I go to do a prescan in silverfast.
scanner starts up
after 3-4 seconds, scan stops and I get a calibration error (f702)
I've checked the lamps, checked the drive belt.
The machine has worked for the last 18 months, but I have not used it in 3 months.
I'm wondering if the issue is hardware, software, or scsi connection somehow timing out. I've switched scsi cards, ports, reboot, etc.
If anyone has experienced this, I'd like to know a better work around than the $2500 + shipping that Aztek suggests.
This happened to me once before, but the lamp just needed alignment...not the case this time.
Does silverfast have a log file of errors to help make sense of the problem?
Many thanks!