LaserSoft Imaging

Hello,

I have had Silverfast UScan.8ba version 6.6 installed (Windows XP) for 4 days, and have been trying to work out keyboard shortcuts for three of those days :)

In particular, I go to "UNDO' (Ctrl+Z), and I get this message...

Keyboard shortcuts changed!

To display darkest poin press F5 etc....
To display lightest... etc..
To darken etc....

Have I setup Sivlerfast incorrectly? (Maybe for MAC?) - I would really like some help here, thanks in advance. - If I could be pointed to some solutions, that will be fine as well.

Dear Robanstan,

you can find a complete list of al shortcuts in this PDF file:
https://www.silverfast.com/download/docu ... -07-03.pdf

kind regards
Arne Ketelhohn

Thanks for your reply Arne, I have seen this doc, and I am doing this......

Quote from PDF doc.
Undo/Redo last operation . . . . . . . . . . . . Command+Z . Ctrl+Z

But every time I touch the "Ctrl" button I get a popup, showing the message I have described, and can't get past it??

Any other ideas:)

Dear Robanstan,

When pressing the CTRL key for the first time you will get a message explaining different options, that message also has a checkbox to prevent the message from showing up everytime the CTRL key is pressed.

Please mark the checkbox and you will see that the CTRL key will be active afterwards.

Cheers

Hi, and thanks for your help.

I did see the popup with the tick, but I didn't relate it to the keyboard functions - I should have thought about it a bit more. Well, I think I will put it down to the last 7 days being over 40C here this week, I have meltdown!

All is good now:)