Page 1 of 1
Geometry math does not work
PostPosted: Wed Jan 07, 2009 4:37 am
by tlum
In SilverFast I have aspect ratio lock broken and am set to "pixel". I enter Original=5782. I enter Scale=100%. Output says 5740. Since when does 5782*1=5740? I enter Output=5782. Scale changes to 100.7%. Original still says 5782. Since when does 5782/5782=1.007 (100.7%)?
Thanks,
-Ted-
Re: Geometry math does not work
PostPosted: Thu Jan 08, 2009 11:57 am
by LSI_Ketelhohn
Dear Ted,
can you please tell me which resolution Q-Factor and Scanner model you are using.
kind regards
Arne Ketelhohn
Re: Geometry math does not work
PostPosted: Thu Jan 08, 2009 11:35 pm
by tlum
Q 1.0, 4,000 DPI, Nikon LS5000.
I think its a problem with the frame markers - the red rectangle - in the view getting stuck against the window extent. As you type the numbers the frame marker changes size. If the side that is not changing size is not at zero then if you type a number that would force the frame outside the window - because of the offset on its other side - I think it picks the number that would be the maximum without going past the window boundary... but I'm just guessing.
-Ted-