LaserSoft Imaging

Dear all,
I just updated to SF v6.4.4r7 using it with my Mediax Workscan 3600, similar to reflecta 3600pro.
In manual it is written that the selected frame (e.g. 36 x 24mm) will be transfered to the default settings for the job manager when a setting is saved.
This doesn't work :-( The job manager allways takes a 34 x 22mm frame which is too smal for my negatives. I have to correct every single frame in the job manager settings to 36 x 24mm. This costs time. When using a complete roll of 36 negatives about 15 minutes. That's not effectiv although I have to scan at least 50 more films.
Can you please help me with this problem.

Thanks and greetings from Germany
Stefan

Dear stefan,

You can copy settings from one Frame to all marked frames.
Select the first frame.
Make all changes.
Save changes by leaving edit mode.
reenter edit mode.
then press the select all button and the copy settings button after that.
you can then select all settings that are to be copied to the other images.


kind regards
Arne Ketelhohn

Hi Arne,
thanks. It works.

Regards
Stefan