LaserSoft Imaging

I recently installed Photoshop CS3 and then the latest version of SF AI studio.

I enable ICM and set a profile, e.g. the Canon manufacturers profile

I then do a scan or prescan and I get a lock up or crash. Deleting the prefs files does not seem to help.

However, if I scan without an ICM profile enabled, the scan works.

The log file after a crash says:

Used NegaFix profile set: <C>

Note: I have always run with ICM profile speficied in the past with no problem.

-----

I found that if I don't set an input profile - everything seems to work fine.

I must not have had that set before. So, I think everthing is now working well. Odd though that SF would crash under the circumstance.

Dear Eric,

I could not reproduce your problem description.
You write that your prescan shows the problem, too. Is this correct?
Did you check the behaviour of SilverFast when run under the SFLauncher?

Best regards
Martin