LaserSoft Imaging

I have the latest version of Silverfast Ai for my Epson 2450.

And every attempt to make a scan starts with the Error

Not enough Memory for prescan left!

I have a gig of Ram on my computer?

Help

Also Firewire has never worked .

Silverfast quite often crashes right after doing a prescan.

I have never had a period of good luck with this software...

Dear Dave

please don't hesitate to contact support: http://www.silverfast.com/problemreport/en.html
How to help support staff to help you: http://www.silverfast.com/faq/1058/en.html

Please note that the purpose of the imaging forum is not to provide personal support. It is intended to serve as a platform for imaging professionals for exchange of experience and communicating ideas [ viewtopic.php?p=9763&highlight=9763 ].
Therefore LSI staff will only provide limited support in the forum.
Thank you in anticipation of your kind co-operation.

Best regards
Sonny Noack
- Manager Technical Support, LaserSoft Imaging AG -

Hello Daveb,

When you installed the software did you leave the box checked on the last screen of the installation, which installs the SCSI drivers? You might try un-installing and re-installing just to make sure that you un-check that box.

Hope this helps!
RAG

Dear Dave

just FYI: Epson 2450 was just re-tested (OSX 10.4, Dual G5) and everything ran smoothly as expected.

Best regards
Sonny Noack
- Manager Technical Support, LaserSoft Imaging AG -