LaserSoft Imaging

I have a Microtek 6100 with Silverfast 6 AI. My problem is that the preview screen does not show me the entire image. Instead, I get a maginfied view (about 3X I would say) of the center portion of the flatbed. Using NMicrotek's EZ-Lock Slide Scanner, I can see the 4 x 5 slot in the center but only edges of the the slide slot.

Any Suggestions?

Don Culp
Burbank, CA

Dear Don

you can turn off highres prescan in the SilverFast Options dialogue (on the "General" tab in the main dialogue window).
Does this change the effect troubling you or did I get you wrong?