LaserSoft Imaging

Good morning folks,

SRD just works fine for me in a single scan.

When I use the Jobmanager and activate in the editting mode SRD for one or more pictures, the SRD action will be shown directly after each individual scan. (Handling the jobmanager is done by the book.)

However if I examine the scans after the jobmanager has finished, all previously by SRD indicated impurities are still in the scans, rendering the SRD actions useless.

Please advise.

Best regards,
Willem

Dear Willem.

Thanks for the interest in our software. I just tested this with the latest DC Pro and frankly could not verify this. Please make sure you have the latest update of SilverFast which we provide for free from our website.
You may also provide the SF_logfile to support@silverfast.com for further problem analysis.

Kind regards.

Hallo Mr Rossee,

The SF_log file is already in your possession due to the SRD problem in PS7 when scanning large slides and no image is being transferred to PS7.

The Silverfast you mention is NOT the version I use. I use Silverfast Ai v6.2.0r3, the latest version as of today.

Kind regards,
Willem

Since this is a general information for all users I am posting the result of our internal test:
We have performed an internal test with scanning an 800mb file, SRD active right into PS --> positive.
There is one item I wanted to clarify. Filters (SRD) and dpi are in relation dependent. This means if you change the dpi after setting SRD it will affect the results.

Kind regards.