Page 1 of 1
Using SF with 2 scanners attached
PostPosted: Mon Jan 05, 2004 8:43 pm
by cowley
I have two scanners attached to my computer, an Epson Perfection 2450 (for which I have SF se at the moment) and a recently acquired Lexmark X1130 All in one Printer Scanner Copier etc.
When I try to run SilverFast with both scanners attached it freezes up and the only way that I can run it is to keep removing the Lexmark software whenever I need to scan film etc.
Is there anyway that I can use SF without removing the Lexmark software
PostPosted: Tue Jan 06, 2004 3:15 pm
by LSI_Rossee
Dear cowley.
I doubt this is a conflict caused on behalf Silverfast. I assume an interface conflict. How are the scanners connected to your machine?
Kind regards.
Using SF with 2 scanners attached
PostPosted: Tue Jan 06, 2004 8:13 pm
by cowley
The Epson is Firewire, the Lexmark is USB. my OS is XP pro, I have 1 gig 2700 ddr memory and 2500 processor, video has 256 ddr memory.
I actually tried loading SF again last night from within Photoshop and it eventually loaded after about 6 - 8 mins.
Re: Using SF with 2 scanners attached
PostPosted: Wed Jan 07, 2004 9:18 am
by LSI_Rossee
cowley wrote:The
Epson is Firewire, the Lexmark is USB. my OS is XP pro, I have 1 gig 2700 ddr memory and 2500 processor, video has 256 ddr memory.
I actually tried loading SF again last night from within Photoshop and it eventually loaded after about 6 - 8 mins.
Can you provide the SF_logfile to
support@silverfast.com?
Kind regards.
PostPosted: Mon Feb 02, 2004 3:09 pm
by LSI_Rossee
Dear Cowley.
All in one scanners have a monitor service application (for one button Email, fax or scan) which is activated during startup.
This monitor should either be deinstalled or deactivated in Autostart.
These kind of monitors are not supported from Silverfast and results in crashes and freezes.
I hope this will explain your problems.
Kind regards.