Page 1 of 1
Prescan green color cast
PostPosted: Tue Dec 23, 2003 9:34 pm
by Bobacronius
I have a MicroTek ScanMaker 8700 and I am using SilverFast AI for scanning. Ever since I first installed the program, I have noticed that in the prescan window, there is always a faint green, transparent stripe (that takes up about 3/4 of the image) going down the middle of the image. It does not appear on final scan. I have reset the prescan to factory settings and retried but this did not remedy the situation. Also, when I use the selection tool, wherever I select on the prescan image, the green tint becomes fainter, almost to the point of disappearing. Any thoughts???
PostPosted: Tue Dec 30, 2003 9:37 pm
by LSI_Noack
Dear Bobacronius
is this true even for the latest
update version available for download from our website?
Happy new year
PostPosted: Fri Jan 02, 2004 7:44 pm
by MicroSF6
I have SFE-6.1.0r7(MicroIT8) installed right now. I believe this is the most updated version, but I could be wrong.
PostPosted: Tue Jan 06, 2004 11:27 am
by LSI_Noack
Dear Bobacronius / MicroSF6,
could you please assist me in eliminating this phenomenon by sending some example screenshots along with the SF_Logfile to
info@silverfast.com (please add "to Noack" in the subject)? Thanks in advance for your co-operation.
Another question: Are sure sure there is nothing like that green tint in the endscan image?
PostPosted: Wed Jan 07, 2004 9:19 pm
by MicroSF6
Well, after doing a couple more test runs, it is showing up in the end scan. I guess before it was just unnoticable. So yes, it is there in the prescan and final scan. I will be sending the screenshots and logfile to you soon.