LaserSoft Imaging

Hi,

We're still using Silverfast 4.2.5r4. This version of Silverfast will display the Input and Output dimensions of a scan in Inches or Centirmeters. In Options under Units of Measure only Inches and CM are available.

Is it possible to display these in Pixels either in our current version or subsequent versions and to set Units of Measure to Pixels?

Thanks,

Richard Urban
Colorado Digitization Program

in the versions that I've owned; v5.0, v5.5 and v6.0; units of measurement included cm, point, pica, pixel and inch.

worthy of note is the fact that Lasersoft continues to use the German translation for point; ie, punkt; in the English Job Manager and in the newly released SF v6 manual.