LaserSoft Imaging

Hi,
I'd like to use the workflow pilot to scan slides in a slide holder.

In manual mode, once we have a prescan I can select frames and it goes and finds the slide frames. As I expect.

But in Workflow pilot, it goes through and at no point in the process does it offer to find frames. It just gives you a big frame and you would have to move it to one position.

This seems very sub-optimal. And in fact makes the workflow Pilot completely useless for slides.

In WorkFlow Pilot I Have Source: Slide, and Task: Print selected.

Thanks for any insight.

Dear user,

At the moment the WorkFlow Pilot is mainly a training tool that only works on single scan frames.

Kind regards,
Arne

I am in agreement with the original poster, that the workflow pilot should allow for the scanning of slides.

Thank you.