Inverting Dust and Scratches Mask
PostPosted: Sat Oct 01, 2016 5:11 pm
I'm trying to draw a small mask in a scan so this part will not be affected by the Dust and Scratch Removal. When I make my mask, the small section is the ONLY part of the image where dust was removed. I need the inverse of this.
The manual says that you can make an inverted selection by holding the Alt key when making a mask. But this doesn't seem to work. How can get this to work?
The manual says that you can make an inverted selection by holding the Alt key when making a mask. But this doesn't seem to work. How can get this to work?