Problem with the final scan
PostPosted: Wed Jan 13, 2016 5:07 pm
Hi everybody,
I am new with this forum, software and film scanning in general so I hope I'm writing in the right subforum. So, last night I purchase the SE version license of Silverfast 8.8 and I tried to scan, for the first time in my life, some 6x6 bnw negatives i shot with my Hassy in last few days. The prescan is surprisingly good than I make all the adjustments but, when I arrive at the final step, the final scan, the file I get is again the negative and not the beautiful, positive image i see on screen. Why? Is that normal? I don't think so!
The same problem happens both in manual and "workflow pilot" mode.
I am using Silverfast SE 8.8 with my girlfriend scanner, CanoScan 9000f Mark II, nothing fancy but is just a test before buying more sophisticated tools and software versions.
I hope i did not bother you and that everything is clear despite my mediocre english!
best regards,
Gerardo Moscariello
I am new with this forum, software and film scanning in general so I hope I'm writing in the right subforum. So, last night I purchase the SE version license of Silverfast 8.8 and I tried to scan, for the first time in my life, some 6x6 bnw negatives i shot with my Hassy in last few days. The prescan is surprisingly good than I make all the adjustments but, when I arrive at the final step, the final scan, the file I get is again the negative and not the beautiful, positive image i see on screen. Why? Is that normal? I don't think so!
The same problem happens both in manual and "workflow pilot" mode.
I am using Silverfast SE 8.8 with my girlfriend scanner, CanoScan 9000f Mark II, nothing fancy but is just a test before buying more sophisticated tools and software versions.
I hope i did not bother you and that everything is clear despite my mediocre english!
best regards,
Gerardo Moscariello