LaserSoft Imaging

I hope someone can help me with this. Im trying to profile my printer in Silverfast AI Studio. Ive gotten as far as scanning and printing the image to the printer. But, when I get to the point that the scanner reads the printed target, I get an error message "could not measure the printed chart, readjust the image and try again. At this point I am stuck.

Thanks

Dear customer,

Have you made sure, that the internal color management of the printer was disabled in the driver setup?
If the internal colorspace rendering is still active the calibration will fail.

Also make sure the ink has dried.
In most cases it takes at least 24h before the colours have reached their final values.
Some ink/paper combinations can take even longer.


Kind regards,
Arne Ketelhohn