LaserSoft Imaging

I'm using an Epson v700 and loading 4 strips of 6 frames into the 35mm holder. I can set all the frames, but I can't figure out how to set the film type as the same for all of them. Nor can I figure out how to set the same resolution. So what I do is click on each one, set the output resolution, and then select the film, then the type, then the speed. For every single frame. Is there a way to apply the settings to every frame before I start the batch scanning?

Dear thechrisproject,

This question has been answered in previous threads.

Please check out the following link:
http://forum.silverfast.com/post24665.html?hilit=frames#p24665

Thanks for your interest

Have a nice day