LaserSoft Imaging

When I go to expert mode and click pencil to edit a film curve, I can not get it to stick. If I hit the pencil again to "end" editing, it simply reverts to the original curve. Is the only way to edit the curve and make a scan to save it?
Thank you

Dear Tyler

you will find a guide to the Negafix tool in PDF format here:
https://www.silverfast.com/show/negafix/en.html

A valuable read is the SilverFast Negafix tutorial in Ian Lyon's Computer Darkroom:
http://www.computer-darkroom.com/sf5-ne ... egafix.htm

If you would like to have the Negafix workflow presented in a movie, you're in the luck, too:
https://www.silverfast.com/showmovie/en. ... Fix-en.mov

Best regards
Sonny Noack
- tech support, LSI AG -

I of course already thoroughly checked all of those resources for an answer. Had I found one I would not have asked here.
Is there perhaps another more appropriate forum for direct answers to user questions?
Thank you,
Tyler