LaserSoft Imaging

Hi,

I am using SE 6 on a Mac G4 running 10.2.8 with a Microtek Scanmaker 4. I am trying to scan some color negatives. When I select negative, the NegaFix box comes up. I select my film (Kodak VC 160 6x6 and others) then close the NegaFix box, and the scanning dialog has flipped back to Positive. repeat, same result, so it never stays on negative and can never scan these. any ideas?

A

The Negafix dialog has to stay open for negative scanning - closing it will switch back back to positive (as you already noticed).

Regards
Ralf

Dear aaronflacke.

The NegaFix dialog is a floating window. As long as this floater is open, you are in NegaFix mode. Move the floater, if it overlaps your other windows. Closing the NegaFix floater means the same as selecting postive.

Best regards
Eric Flyvbjerg.

d'oh!

thanks guys

A