LaserSoft Imaging

I just downloaded the SF Ai 6 upgrade to my Nikon LS400 scanner and got by email a serial number IT8 included. After uninstalling SF 5.5 I installed the SF 6 upgrade and used the IT8 serial number but SF6 askes for the basic serial number which I didn't get yet from Lasersoft. The serial number I have is only for deblocking the extra SF features like IT8. So I need another serial number to start the basic SF Ai 6 version.

Could you please fix this problem asap...
Thanks!

Dear Jean-Pierre,
please write to our Support e-mail and you will be given a new number.

this is NOT a problem, this is a feature
If you by a new version of SilverFast you old serial numbers do not apply to this new version.

Mr Engelhardt,

There is some misunderstanding here....
The serial number I used is the serial number I got when buying the new SF6 upgrade not the one from my previous SF 5.5 version. Like it was asked for I mentioned that I needed the upgrade for IT8. I got a serial number that only allows to deblock the IT8 feature not to start up the basic SF6.

I wrote to LS support but got no answer yet.


At the last upgrade to SF5.5 there were also many problems with serial numbers...Hope this one will get fixed soon too.

Thanks.

Dear Verbeke,
I remember your name, because it is that e-mail which was returned yesterday as undeliverable.
Can you please write an e-mail again today (preferably with a fax number as well) so I can provide you with your new serial no.?