LaserSoft Imaging

Hi,
we purchased a Microtek ScanMaker 8700 scanner with Silverfast 5, but we would use Siverfast with a Microtek ScanMaker III instead. Can we do that?

thanks,

Rubino Saccoccio
Meta Srl

Using SilverFast Ai for SM 8700 with other Microtek scanners

The strength of SilverFast is to be dedicated to each different scanner-model. Only that assures maximum quality for each scanner model. Especially with Microtek different development command sets are needed for each model.

In order to get SilverFast working with a Microtek SM III, you would have to get the appropriate version of SilverFast for it.

Of course you can buy SilverFast Ai for SM III directly from us, or purchase SilverFast SE for SM III for only 49 US$ online.

https://www.silverfast.com/show/silverfast-se/en.html

<font size=-1>[ This Message was edited by: President_LSI on 2002-06-12 22:06 ]</font>