LaserSoft Imaging

Hi,
I recently bought the Epson 4990, I have to say I am a newbie on using scanner, using it with a Windows XP. Everytime I started the scanner software I get this error message, "This application has failed to start because DICELib.dll was not found. Re-installing the application may fix this problem"

I can't seem to find a solution to this problem, any help is much appreciated, thanks in advance.

../azul123

Greets azul123,

I have seen this problem reported in the past, but I was under the impression that it was fixed in the Epson 4990 version of Silverfast. Here is the previous thread:

http://www.silverfast.com/forum/viewtopic.php?t=2581&highlight=dicelib+dll

I have recently purchased the Epson 4990 also and my Silverfast software installed without a hitch (well, actually, I did have one problem: it uninstalled the Silverfast software for my Epson 3200 which I most certainly did NOT want, but I digress...) Perhaps you should email tech support and see what they can do for you.

Good luck!

Helpful Corn wrote:Greets azul123,

I have seen this problem reported in the past, but I was under the impression that it was fixed in the Epson 4990 version of Silverfast. Here is the previous thread:

http://www.silverfast.com/forum/viewtopic.php?t=2581&highlight=dicelib+dll

I have recently purchased the Epson 4990 also and my Silverfast software installed without a hitch (well, actually, I did have one problem: it uninstalled the Silverfast software for my Epson 3200 which I most certainly did NOT want, but I digress...) Perhaps you should email tech support and see what they can do for you.

Good luck!

Thanks Helpful Corn, I followed the link you posted and ask Tech Sup to send me the missing DICELib.dll file.

Appreciate the help.

../azul123

Dear users

jacksain had presented <a href="http://www.silverfast.com/forum/viewtopic.php?p=12915&highlight=#12915">an alternative solution</a> in another thread in this forum.

Best regards
Sonny Noack
- Manager Technical Support, LaserSoft Imaging AG -