Page 1 of 1
"No SCSI controller detected"
PostPosted: Thu Mar 17, 2005 10:17 pm
by exfish
Hi there,
Installed Silverfast AI 6 for use on an Nikon le4000.
Program wont start, I keep getting
"No SCSI controller detected" on startup of Silverfast.
Can anyone please advise how to solve this problem.
Exfish
PostPosted: Sun Mar 20, 2005 11:54 pm
by RAG
Hello exfish,
I'm not familiar with this model. Does it in fact connect to your computer via the SCSI port?
PostPosted: Mon Mar 21, 2005 12:56 am
by exfish
Hi Rag,
No in fact it is a firewire scanner, that had me puzzled as well, but I can't get into the program to see if there are preferences that will allow me to change.
It just throws up that warning at startup.
David
PostPosted: Tue Mar 22, 2005 5:27 pm
by RAG
exfish,
Try un-installing and re-installing the application. When you install it again you will notice a check box on the final dialog box regarding SCSI. Un-check that box since you don't have an SCSI scanner and that should take care of the problem for you.
PostPosted: Wed Mar 23, 2005 9:54 pm
by exfish
Hi Rag
Thanks for that.
I tried uninstalling and reinstalling, but there is no last page, no dialog box, and no check box, after selecting where to place the program, it runs straight into the reboot page.
So I'm no better off, would you have any other suggestion?
David
PostPosted: Thu Mar 24, 2005 4:39 am
by RAG
exfish,
Is your computer a MAC or Windows based system? I was assuming Windows.
If it is Windows based the screen I was talking about is the one with the finish button at the end of the installation.