SF Ai6 Install Problem with Nikon AX1200 Flatbed Scanner
PostPosted: Sat Jun 14, 2003 8:52 pm
Hi,
The problem is with the SCSI ID# not being recognized. I'm using a Mac G4 with an Ultra SCSI card that has a SCSI ID of #7. The SF Ai6 SCSI IDs only go up to 6. The AX1200's ID can be set to 7. So the issue appears to be with the SF Ai6 app - is there any way around the SCSI ID problem? Or do I need to buy SF SE instead (did not have a problem with the SE demo version)?
Any tips will be greatly appreciated!
-Craig
The problem is with the SCSI ID# not being recognized. I'm using a Mac G4 with an Ultra SCSI card that has a SCSI ID of #7. The SF Ai6 SCSI IDs only go up to 6. The AX1200's ID can be set to 7. So the issue appears to be with the SF Ai6 app - is there any way around the SCSI ID problem? Or do I need to buy SF SE instead (did not have a problem with the SE demo version)?
Any tips will be greatly appreciated!
-Craig