LaserSoft Imaging

Dear LSI
I am now trying to get my new Braun 6000 to work. I had Reflecta before, but never had the time or the energy to get it to work fully with SF8.

I have scanned the calibration targets after the instructions on page 84-85 in Mr Segal's book, and saved these with what I thougt was appropriate names in a new folder on one of my drives.
When trying to find these - in setting CMS preferences (page 86) I am not successful. I can see a number of names, starting with SF, but of course not my newly scanned target.
Hence - must these calibration targets reside in a predefined folder (which?) and/or follow a predfined naming convention to be seen. Any other relevant information ?
My idea was to name them B6000K64 , B6000Agfa and B6000Fuji. I have in total some 30.000 slides to scan, the vast majority of the slides are Agfachrome 50S, Kodachrome 64 or Fuji Provia. Of course all names can start with SF if this is needed.
Best Regards
Lennart Malmsten
Lidingö
Sweden

Dear Mr Malmsten,

You only need to click the IT8 button in the SilverFast window.
If you use one of our targets, the IT8 calibration is a fully automated process.
The created ICC profile directly takes effect after it is finished.

Kind regards,
Arne Ketelhohn