After a scan the phote is not displayed in photoshop
PostPosted: Fri Jun 11, 2004 11:55 am
by KKBln
Scanner HP 6300c
Windowa XP
Silverfast V 6.2.1r4
When a photo is scanned, SF saves it to a file, although in the Options the field "show the picture when the scan is done" is activated.
What can I do?
PostPosted: Sat Jun 12, 2004 2:48 pm
by LSI_Noack
Dear KKBln
you probably want to scan the file directly into your graphics manipulation application (e.g. Photoshop). Please find the general tab in the scan control window (smaller window on the left hand side).
There you want to change the scan mode from "Normal(File)" or Batch(File)" (SilverFast
Ai only) to "Normal" or "Batch".
Please note that these modes are only available if SilverFast had been called from within the graphics app (e.g. from the "File" -> "Import" menu of Photoshop).
PostPosted: Tue Jun 29, 2004 3:37 am
by carlbutler
Thanks for the tip on getting my scans into Photoshop again..
After upgrading to 6.2.0r8 I lost that option.. I have been scanning to file until I spotted this post from LSI tech.
I DO notice, however, that on the control panel, I no longer see the Image Type button change to anything other than Standard. The Landscape, Skin tones, etc seem to apply their changes to the preview, but the button always reverts to (shows) Standard.
I believe that this started after upgrading to OS X 10.3.4
I am using a HP Scanjet 4c with a Transparency Adapter and Silverfast-SE 6.2.0r8.
javascript:emoticon(':roll:')