LaserSoft Imaging

Silverfast HDR Studio is just perfect for my Nikon D200 images (and a very large number of scanned slides/negatives/prints/artwork..). I'm pleased with the functionality. More than this - I'm finally getting stuff from RGB to CMKY for printing reliably. All that being said, I find the VLT cumbersome to use and would like to find a way to bypass the it - or at least the album function so that I can access and process images from my disk directly without having to import them into the VTL. Anyone know how to do this? Either that or, is there a command line sequence that I can use to immediately open an image? Thanks.

Dear SMF

thank you for your interest in LaserSoft Imaging's software products :)

> Options > General > uncheck "Open VLT at startup".

Please note that the purpose of the imaging forum is not to provide personal support. It is intended to serve as a platform for imaging professionals for exchange of experience and communicating ideas [ viewtopic.php?p=9763&highlight=9763 ].
Therefore LSI staff will only provide limited support in the forum.
Thank you in anticipation of your kind co-operation.

Best regards
Sonny Noack
- Manager Technical Support, LaserSoft Imaging AG -