Page 1 of 1

Silverfast 6.4.4r2: Prescan problem?

PostPosted: Sun May 07, 2006 1:22 pm
by RonG
I have an ArtixScan 1800f; no problem with the previous version of Silverfast. But right after I upgraded to this version, I noticed that when I scan documents on the flatbed (not negs below on the carrier), the prescan doesn't work. It starts up and then rapidly goes to the end leaving either no image or just long lines. Scan always works OK.

PostPosted: Mon May 08, 2006 9:30 am
by LSI_Noack
Dear Ron

did you try deleting the prefs?
More info, cf. SilverFast's service dialogue (> FAQ).

Best regards
Sonny Noack
- Manager Technical Support, LaserSoft Imaging AG -

Thanks. I think that worked

PostPosted: Mon May 08, 2006 1:22 pm
by RonG
I just tested another flatbed scan this morning and it was OK.

PostPosted: Tue May 09, 2006 3:28 pm
by LSI_Noack
Dear Ron

thank for telling me =)

Kind regards
Sonny Noack
- Manager Technical Support, LaserSoft Imaging AG -