LaserSoft Imaging

I am confused about how to proceed when upgrading from Silverfast Ai (that came with my Microtek 120 tf scanner) to SilverFast Ai Studio. I am asked to enter my SilverFast Ai serial number, but there is an Important Note that says if you have a serial number with IT8 calibration to enter that number. I am using IT8 calibration that came with my scanner but don't know where that serial number is located. There are 2 serial numbers that are on the box of my software CD (one for Artixscan 120 & one for Silverfast HDR). Could you please advise.
Best,
J. Paul

J. Paul,

I don't believe this applies to you since your IT8 is not from LaserSoft. I mean how would they know the serial numbers of everyone elses IT8 targets, right?

Hope this helps!