Demo Ai Studio 8

[peter k]

Trying the Muti-exposure on the demo.. made sure that the item was highlighted, in vertical column, and then scanned.. it only seemed to do one scan. What am I doing wrong, or misunderstand.
I watched the movie several times.. I was not able to access the muti scan out of the siverfast menu option at top left, but did what I thought was the same by highlighting the vertical selection.

[LSI_Ketelhohn]

Dear customer,

The MutliExposure option is active if the ME icon has a red dot in it.

kind regards,
Arne Ketelhohn.

[peter k]

Ok the ME icon in the vertical column is active... and I'm to understand that it will do two pre-scans?

If so I see it making only one pass.. where am I going wrong?

[peter k]

Also I'm trying to get some regular scanning done in SE 8, is there a way I can have the demo and SE 8, loaded, but only one in use at a time, rather than having to constantly change serial number procedure?

[LSI_Ketelhohn]

Dear customer,

The Preview only does a MultiExposure scan if you activate the MultiExposure preview in the preferences special tab.

SilverFast uses one installation for all versions if you want to switch between SE and a Ai Demo you will have to change serials.


kind regards,
Arne Ketelhohn.

[peter k]

Well I looked up in the upper left corner, but could not find the heading shown in movie... I think it was SCANFAST, that they click and shows where they go to for preferences.. remember I have demo.. perhaps cant do ME.
I'm in SE 8 right now, but have looked at movie several times over weekend trying to get ME.

If it can be done in demo... da now what do I do now?
ahh.. good suggestion realign knot on top of shoulders..

[peter k]

Just verified... on Movie it shows upper left hand corner SilverFast 8, then image... I do not get SilverFast 8, just image and the others.. as I have stated using demo.

What needs to be done?

[peter k]

problem solved.. thanks