LaserSoft Imaging

I had just gotten in to SiverFast 8 and was learning how to scan using the program and noticed that I could twist, the rectangle when I was setting up the scan, via the prescan, by just moving inside the image in a corner up or down. I not talking about the flip, rotate button, this was from inside the red rectangle.
Am I nuts.. no.. but how the heck did I get it to do that? I must have hit something!

Some of my old 35mm slides are angled within the holder and this would be a helpful.
V700 scanner.

Hi there,

if you check the red scanning frame, towards the middle of each side you will find a semi-circle. Placing the mouse right above (the cursor changes) will allow you to free-rotate your scanning frame by any angle.

Cheers

ah thanks.. will give it a try in a few moments..